Logotipo del repositorio
Comunidades
Todo Digital INTA
Iniciar sesión
¿Nuevo Usuario? Pulse aquí para registrarse ¿Has olvidado tu contraseña?
  1. Inicio
  2. Buscar por autor

Examinando por Autor "Medler, Jens"

Seleccione resultados tecleando las primeras letras
Mostrando 1 - 2 de 2
  • Resultados por página
  • Opciones de ordenación
  • Cargando...
    Miniatura
    PublicaciónRestringido
    Medidas de Emisiones Radiadas de Alta Sensibilidad en Sistemas Espaciales
    (INSTITUTO TECNOLÓGICO DE ARAGÓN, 2025-11) Medler, Jens; Jiménez Lorenzo, María
    Durante los ensayos de emisiones radiadas, la proximidad del nivel de ruido al límite aplicable tiene un impacto directo en los resultados. Este aspecto debe ser tenido en cuenta durante las medidas de emisiones radiadas en sistemas espaciales donde se definen límites muy restrictivos en determinadas bandas de frecuencia (conocidas como notches) para proteger los sistemas electrónicos sensibles como son los receptores. En esta presentación se describe la influencia del nivel de ruido en los resultados obtenidos y se evalúan diferentes métodos para mejorar la sensibilidad del sistema de medida y su posible efecto en el resultado final del ensayo.
  • Cargando...
    Miniatura
    PublicaciónRestringido
    Radiated Emission Measurements in Close Proximity to the Noise Floor
    (IEEE, 2025-05) Jiménez Lorenzo, María; Medler, Jens
    Radiated Emission (RE) measurements in close proximity to the noise floor can lead to an overestimation of the measurement results, which may cause a failure situation when performing the limit check. This may be the case when this test is performed on an aerospace system because of the low electric field limits defined in certain frequency ranges to protect critical receiver bands and a high sensitivity of the measuring system is required. Standards define a requirement for the noise floor to be at least 6 dB below the applicable limit. This is not always feasible when measuring low limit frequency notches using the standard bandwidths and test setups. This paper focuses on the analysis of three different ways of decreasing the noise level and improving the sensitivity of the measuring system: the use of low noise preamplifiers, the use of high gain antennas and the narrowing of the measuring bandwidth.
footer.link.logos.derechosLogo Acceso abiertoLogo PublicacionesLogo Autores
Logo Sherpa/RomeoLogo DulcineaLogo Creative CommonsLogo RecolectaLogo Open AireLogo Hispana

Dspace - © 2024

  • Política de cookies
  • Política de privacidad
  • Aviso Legal
  • Accesibilidad
  • Sugerencias